Domed Decal?

Weve updated ourPrivacy Policyand by continuing youre agreeing to the updated terms.

When you visit our site, pre-selected companies may use certain information on your device to serve relevant ads and for analytics purpose.

Bass Cat Owners is a forum for Bass Cat owners to learn, share, and discuss more about their boats.

January 26th, 2015, 1:03 am12015-01-26T01:03

I noticed today, as I was cleaning my PII, that one of my domed decals was starting to peel up from the boat.  What is the best product to use to get it to lay back down? Thanks in advance.

January 26th, 2015, 1:23 am22015-01-26T01:23

You didnt say how old your boat was. Id just replace it. I would think a repair would just come loose again. Removing it and thoroughly cleaning with alcohol before installing the new one should be your best choice.

January 26th, 2015, 1:45 am32015-01-26T01:45

Both sides eventually peeled off my P2 (2013) I just replaced them. I called BCB and told them what happened, and since my boat was new at the time, they sent to me FOC!

January 26th, 2015, 2:18 am42015-01-26T02:18

One on my 2014 Sabre FTD came off first time in the water. Just running up and down the lake a few times. I bought a new one and replaced it. Prep is extremely important in sticking stuff on. I would say the first one had a film of something left on the boat and just didnt stick very well.

January 26th, 2015, 3:54 pm52015-01-26T15:54

The BCB decals on the hull are more susceptible to damage as most boats dont have hull decals on the rear corners where they get contact to many things. You bump stuff all the time with those rear corners, or things but those rear corners.

January 26th, 2015, 5:54 pm62015-01-26T17:54

January 26th, 2015, 6:21 pm72015-01-26T18:21

January 26th, 2015, 7:07 pm82015-01-26T19:07

Anybody got any tips on prepping the hull and applying new ones? Want to make sure I get it done right the first time.Clean good with denatured alcohol. Warm temps!

January 26th, 2015, 7:51 pm92015-01-26T19:51

When mine came off, I found it easier to get the sticky residue off first with goo gone.  Then I used alcohol. Like Dan says, a warm day or heat gun.

January 26th, 2015, 8:20 pm102015-01-26T20:20

When mine came off, I found it easier to get the sticky residue off first with goo gone.  Then I used alcohol. Like Dan says, a warm day or heat gun.

That was my first thought.  Goo Gone, wash, rinse, dry, wipe down with alcohol.  Denatured for cleaning, bottled for getting in the right frame of mind to do the job.  LOL

You are posting as a Guest without being logged in.Log In nowUsername:Subject:Confirmation of reply:>

10 posts Page1of1

); $fa_cdn.remove(); $span.remove(); )(jQuery);

+ response.data[i].avatar + response.data[i].username +

+ response.data[i].avatar + response.data[i].username +