PU Doming resin Clear polyurethane s Domg polyuthane

CPU-76-115D can be applied to various substrates. Its applications include molding models, doming decals, nameplates and ornaments, and encapsulating electronic parts.

Pb below the limit, others not detected

* These items are provided as general information only. They are approximate valuesand are not considered partof the product specification.

CPU-76-115D is an excellent two-component polyurethane resin. It has high transparency and great adhesion to various substrates. Its durability is pretty impressive. It can withstand vicious surroundings, including cold, hot, dry or wet environments.

1. Keep the operation place as dustless as possible to gain products with better appearance. The ambient temperature is recommended at between 15C and 25C.

2. Calculate the needed amount in weight. Sequentially pour Part A and Part B into a clean and dry container. Unused components must be tightly closed to prevent contamination of dust and moisture from the air.The weight ratio of Part A to Part B is 1:1.

3. Immediately agitate the mixture with an electric stirrer or manually with a stirring blade for 30 seconds to 1 minute till it is well mixed.

4. Place the well blended mixture in a degassing equipment for 1 to 4 minutes.

5. Immediately start dispensing the mixture onto substrates.The operating time is about 20 to 40 minutes.Higher the ambient temperature and more the blended amount, the operating time would be shorter.

6. Put the coated substrates in an oven. Higher the oven temperature, they can be cured faster. Normally they can be cured in two hours at 80C. For other curing temperatures and periods, please refer to the following table. As therere always some tiny bubbles remaining in the mixture, a blast of hot air by a flame gun is helpful to eliminate residual bubbles near the surface.

Notice: These values are based on the test of our present laboratory test specimens.

1. Please wear a mask of charcoal filter, gloves and goggles while operating. And maintain good ventilation.

2. In case contacting the resin, no matter which part of the body, please wash it with plenty of soap and water at

once. Seek medical attention, if you feel unwell.

Liquid Urethane for Mold Making & Casting

PU Coating for Wire Guide Roller (WGR)

PU V Pulley for Wafer Slicing Equipment

Liquid Urethane for molding & Casting

Liquid Urethane for molding & Casting

PU Coating for Wire Guid Roller (WGR)

PU V Pully for Wafter Slicing Equipment

Water-based Adhesive (For Shoes/Economical grade)

Liquid Urethane for molding & Casting

Two-component casting PU material for concrete mold

TPUCO Develops Economical Grade Water Based PU Adhesive

Taiwan PU Corporation (TPUCO) will exhibit at the worlds largest plastic and rubber fair, K2016


© Taiwan PU Corporation All rights reserved.Tel886-2-22991666Fax886-2-22991888E-mail

Taiwan PU Corporation (TPUCO) is a professional manufacturer and a world-class factory ofPU Doming resin, Clear polyurethane resin, Doming polyurethane.With our leading producing technologies, TPUCO can produce various kinds ofPU Doming resin, Clear polyurethane resin, Doming polyurethaneaccording to clients requirement.TPUCO assures customers of the reliability and the top quality of thePU Doming resin, Clear polyurethane resin, Doming polyurethane.MoreCasting CPU,TPU Granules,PU Adhesives & Hot-Melt,Pneumatic Tubes,PU Beltings,PU Moulded Products.